No announcement yet.

Hot water problem with Glowworm Betacom 24c

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hot water problem with Glowworm Betacom 24c


    This is a duplicated message from the Glowworm subsection:

    I had hot water and heating problems. I had a power flush done and also had the heat exchanger cleaned. This all seemed to do the job, but then about 1-2 weeks later the hot water became worse and worse and now is non-existent. Heating is fine.

    I can't afford to throw much more money at this problem.

    Can anyone offer a range of desk top diagnoses? The person who did the power flush says he'll come back to diagnose for an extra 50, he was at the property only two weeks ago and went through everything then!

    Quite fed up.



  • #2
    it sounds like the flush wasnt very good and sludge has now blocked up the plate heat exchanger. Any decent installer would come back and check for free.